How to improve the success rate of nail nail making machine? Nail making machine in the nail should keep the machine clean, do not use the rusty wire nail, nail should maintain the keenness of the sword, dealing with the nail making machine oil lubrication, ensure the lubrication parts in good lubrication. Boot, boot before all debris removal to the machine, then use human rotating flywheels week, check machine trouble-free rear can boot. After start-up must stay behind the machine run properly can throw into line handle, wire nails, should be stopped before downtime into line. Machine shall, from time to time, pay attention to the part of the friction parts in the process of temperature change and abnormal noise. Don't be adjusted to work when the machine is running.
Keep the keenness of the sword, need to replace parts should use the original specification. Nail, wire feeding institutions should be adjusted to make end out appropriate amount of nail silk, triangle pre-tightening force should Nail machine supplier be transferred to the appropriate location. Nail tools of high and low position and nailing about location should be appropriate. Adjust the nail making machine wire feeding mechanism, make the nail wire end out properly. Nail making machine clamping hole big or subdivision surface gap is too big, should repair or change mould. Nail material should be not good, choose suitable material, nail making machine wire nail scissors can cut appropriately.
"Holding" nail "clamping" part of the machine is mainly used for the nail fixed, in the process of nail, regardless of the size of the nails, use nail making machine, nails clamping device used for embedded buckles each other clamping structure inside is hollow, and at one end of the device is equipped with embedded slots. And a clamping device, embedded in the caulking groove Coil Nail Making Machine and on its side with one extends to the connection outside the ontology, but on the other side is equipped with clamp arm. Because of the clamp arm is convex Lou at outside, so just to nail, with this device, the operator don't need directly by hand on a nail, at the same time also can have the effect of fixed nail, ensure the safety of nail making machine operation.
Nail making machine into line machinery (in line) with screw was fixed in nail pattern in front of, in the process of nail, the nail into the line on one end of the tie rod and crankshaft eccentric disc is linked together, and Coil nail machine the other end is connected to a transmission arm. When the machine into line eccentric disc will follow synchronous rotation, and affects the pull rod movement back and forth, prompting the transmission arm swinging back and forth around pin, eventually achieve the goal of into line.
How to control in on-line? Before not boot, can be manually pull (into line control handle can control into line, stop line at any time, and appropriate adjustments in line on the eccentric disc is rod, also can realize the into line length adjustment. If want to make the time changes into a line, just need to rotate the Angle of the eccentric disc into the line, to ensure that everything can satisfy the requirement of nail.